Allied Telesis AT-S102 - Manual (Page 163)

Converteon Management Software User’s Guide
163
EgrRL This column displays the settings of the egress rate limiting filters on
the ports on the AT-CM Line Cards. The value “0” means rate
limiting has not been set on the port. This is the default setting. For
instructions on setting this parameter, refer to “Configuring the Port
Parameters on the AT-CM Line Cards” on page 169. This feature is
not supported on the AT-CV Line Cards.
OAM This column, which applies only to AT-CM Line Cards that are
operating in an OAM operating mode, displays the following OAM
client information:
A This alternates between “*” and “o” when Port A, the fiber optic
port, is transmitting OAMPDUs. Otherwise, it remains “o”.
B This alternates between “*” and “o” when Port A is receiving
OAMPDUs. Otherwise, it remains “o”.
C This displays the operational state of the OAM client on Port A.
The possible states are:
* - Operational
A - Active Send Local
D - Disabled
L - Active Send Local
M - Peer Remote Reject
P or W - Wait
R - Peer Local Reject
1 - Active Send Remote 1
2 - Active Send Remote 2
Note
The AT-CM Line Cards have to be in the OAM operational
state to support the OAM-based features. Achieving this state
may take a line card up to two minutes when it is powered on
or reset, because it has to initialize its management software
and negotiate the OAM state with its remote counterpart.
This column does not apply to the AT-CV5M02 Management Card
or to the AT-CV Line Cards.
Table 19. Module Status and Configuration Menu
Column Description
00*
C
B
A