Allied Telesis AT-S102 - Manual (Page 166)

Chapter 6: Configuring the Media Converter Line Cards
166
Displaying the Parameter Settings of the AT-CM Line Cards
Menus
To view the current parameter settings of the AT-CM Line Cards from the
menus:
1. From the Main Menu, select Module Status and Configuration to
display the Module Status and Configuration menu shown in Figure 58
on page 158.
2. From the Module Status and Configuration menu, select the AT-CM
Line Card you want to view. You can view only one line card at a time.
The Module Configuration Menu in Figure 63 on page 169 is
displayed.
3. Select Line Card Configuration to display the menu in Figure 72 on
page 183.
4. Select Display Current Configuration. An example of the window is
shown in Figure 61.
Figure 61. Display Current Configuration Window
Display Current Configuration
Slot: 11 Module: AT-CM302
Operational Mode: Link Test + OAM Visible Mode
Port A(100BaseFX) Port B(100Base-TX)
Port Enable: Enabled Enabled
Negotiation: -- Manual negotiate
Duplex: -- Full
Speed -- 100 Base (100Base-TX)
MDI/MDIX: -- MDI
Flow Control Enable Enable
Ingress Rate Limit: No Limit No Limit
Egress Rate Limit: No Limit No Limit
OAM Configuration
Admin State: Enabled
Mode: Active
Maximum OAMPDU Size: 64
Unidirectional Support: Yes
Loopback Support: Yes
Event Support: Yes
Variable Retrieval Support: Yes
Return to Line Card Configuration...