Artesyn ARTM-831X Installation and Use (June 2014) - Manual (Page 57)

Controls, LEDs, and Connectors
ARTM-831X Installation and Use (6806800M76E) 57
3.2.2 Connectors
The blade provides ethernet interfaces and the BITS/SSU (E1/T1) Interface at its face plate.
3.2.2.1 Faceplate Connectors
One 1x4 low-profile, shielded RJ45 connector with integrated LED (green/yellow) is available at
the ARTM-831X face plate, providing four ports Ethernet connectivity.
Two 1x1 low-profile, shielded RJ45 connectors (w/o LED) at the ARTM-831X face plate provide
access to the 2 ports of the BITS/SSU interface.
Table 3-2 Ethernet Interfaces - RJ45 Connector Pin-out
Pin 10Base-T / 100Base-TX 1000Base-T
1 ETH_TX+ ETH_DA+
2 ETH_TX- ETH_DA-
3 ETH_RX+ ETH_DB+
4 ETH_DC+
5 ETH_DC-
6 ETH_RX- ETH_DB-
7 ETH_DD+
8 ETH_DD-
Table 3-3 E1/T1 Interface - RJ45 Connector Pin-out
Pin Signal
1 E1/T1_RX+
2 E1/T1_RX-
3 NC
4 E1/T1_TX+
5 E1/T1_TX-
6 NC
7 NC