Artesyn ARTM-831X Installation and Use (June 2014) - Manual (Page 29)

Introduction
ARTM-831X Installation and Use (6806800M76E) 29
1.2.1 ARTM 8310_base
 Base PCB
 Four 10/100/1000Base-T Ethernet interfaces (Rj45)
 10Gb Ethernet interface via SFP+ pluggable transceiver
 Synchronous Ethernet (locked to 25MHz SyncCLK from System Synchronizer)
– All four 10Base-T and 100Base-TX mode ports
– All four 1000BASE-T mode ports when configured as master Tx/Rx
– Both 10GBASE-LRM mode ports
– Both 1000BASE-LX/SX (1GBE bypass) mode ports
 CLK synchronization options (recovered receive CLK to Reference-CLK selection as input
source to the system synchronizer):
– BITS (2x, RJ45) option installed on base board
– One of either 10Gb Ethernet ports
– One of four 100/1000BASE-T ports
 IP only version (without expansion board):
– Synchronous Ethernet
– No BITS option installed
– No SFP for OC3 and expansion option