Artesyn ARTM-831X Installation and Use (June 2014) - Manual (Page 184)

TSI FPGA
ARTM-831X Installation and Use (6806800M76E) 184
0x1410 RtmMatchBaseExtFp
gaVerReg Matching BaseExtFpga Version Register (32bit) [Hw: syn,
WAck1, RAck1]
The version of the matching BaseExtFpga (since BaseExtFpga
extends RtmFpga) is read. Must match always exactly the
version in RtmMatchBaseExtFpgaVerReg within BaseExtFpga
determined by compilation
0x1414 ModulTypeFnctReg Module Type and Functional Revision Register (32bit) [Hw: syn
, WAck1, RAck1]
The module type and functional revision of the module the
Fpga is upon. The value is determined by pull-up/pulldown
resistors.
0x1418 SyncErrMonReg Synchronisation and Error Monitor Register (32bit) [Hw: syn,
WAck1, RAck1]
This register monitors the synchronisation and error status of
different functions. If a function signals a out of sync or an error,
the respective bit is set. It can be reset by writing the respective
bit in SyncErrMonResReg
0x141C SyncErrMonResReg Synchronisation and Error Monitor Reset Register (32bit) [Hw:
syn, WAck1, RAck1]
The bits of this register reset the respective bits in
SyncErrMonReg. Writing a 1 to a bit resets the corresponding
bit in SyncErrMonReg. The corresponding bit is kept reset until
writing a 0 re-enables its monitor function again.
0x1420 SyncErrMonMaskRe
g Synchronisation and Error Monitor Mask Register (32bit) [Hw:
syn, WAck1, RAck1]
The bits of this register mask if a SyncErrInterrupt is generated
when the respective bits in SyncErrMonReg are set.
0x1424 DebugLedReg Debug LED Register (8bit) [Hw: syn, WAck1, RAck1]
This register controls the condition of the lower 3 LEDs for
Debug purposes
Table 9-5 RTM FPGA Address map Overview (continued)