Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 922)

L-force | PLC Designer
Device Editors
920 DMS 4.1 EN 03/2011 TD29

Addresses
Station address: The allowable range is from 0 to 126. Each device newly inserted on a
bus line is automatically provided the next higher address. (note: Address 126 is the
default DP slave address). Manual entry is possible; addresses are tested for
duplication.
Highest station address: The highest station address (HSA) assigned on the bus is
displayed. Here, a lower address can also be entered in order to narrow the GAP range
(that is, the address range within which the search for newly-active devices is carried
out).
Mode
Auto clear mode: If this option is activated, in error case the outputs of the slaves will
be switched to the save state and the master will change from "operate-" to "clear-"
state.
Automatic startup: If this option is not activated, the master must be started
manually. However it depends on the driver, whether the setting is evaluated.
Parameters
These bus parameters describe the timing of the communication.
Baud rate [kBits/s]: The entries given by the device description file (GS?-file) are
available here for selection, but only a transmission rate supported by all slaves can be
entered.
Use defaults: Activate this option, if the values displayed in the parameter table
should be reset to their defaults corresponding to the currently set baud rate.