Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 243)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 241
Y offset: By default is 0. Entering a positive value shifts the chart downwards, thus
possibly increasing the height of the working sheet. Entering a negative value shifts
the chart upwards, thus only possible, if there is space between the uppermost
element and the upper window border.
If you enter invalid sheet size values, an error message dialog will pop up, also listing
the given restrictions.
Abb. 75 Working Sheet size, error message dialog
12.7.3 Negate
Symbol:
This command (category CFC) is used to negate inputs, outputs, jumps or RETURN
commands. The symbol for the negation is a small circle on the connection. To assign a
negation select the respective input or output pins of the element and perform the
command. See CFC Editor, Cursor Positions for the possible cursor positions for
selection.
A negation can be deleted by negating again.