Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 812)

L-force | PLC Designer
General Editors
810 DMS 4.1 EN 03/2011 TD29

Text properties (HorizontalAlignment, VerticalAlignment, Font)
These are static definitions, for a dynamic definition of the font notice category 'Font
variables'.
HorizontalAlignment Horizontal alignment of the elements' text: LEFT /
HORIZONTAL / RIGHT R,rR,E,P,L,pL,C,
F,Bu,Im Ta,Te,Sc
VerticalAlignment Vertical alignment of the elements' text: TOP /
VCENTER / BOTTOM R,rR,E,P,L,pL,C,
F,Bu,Im Ta,Te,Sc
Font Font type, color and size to be used for the
elements' text; button opens the standard
dialog for defining the font;
R,rR,E,P,L,pL,C,
F,Bu,Im Ta,Te,Sc
Arrow (only for Meter: Arrowtype, Arrowcolor, Arrow start, Arrow end, Additional
arrow)
Arrowtype the drop-down menu provides four different shapes for the
arrow:THIN_NEEDLE, THIN_ARROW, NORMAL_ARROW, WIDE_ARROW M
Arrowcolor color of arrow M
Arrow start angle (in degree) between left boundary of tachometer and horizontal
axis ranging from 0 to 360 M
Arrow end angle (in degree) between right boundary of tachometer and horizontal
axis ranging from 0 to 360 M
Additional arrow this checkbox being activated a second arrow will be displayed which is
located in the scale area and opposed to the original arrow M
Bar ( Diagram type, Orientation, Running direction)
Diagram type the drop-down menu provides three different possibilities for locating
the bar with respect to the scaling : BAR_INSIDE_SCALE,
SCALE_INSIDE_BAR, SCALE_BESIDE_BAR BD
Orientation chose between HORIZONTAL and VERTICAL orientation of the bar; in
case of the scrollbar, the orientation results from the ratio of length to
widthand may not be edited. BD SC
Running direction chose between LEFT_RIGHT (for a bar growing from left to right) and
RIGHT_LEFT in case of a horizontal bar, or between BOTTOM_UP and
TOP_DOWN in case of a vertical one
BD SC