Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 539)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 537
12.35.4 PLC Designer Frame
View commands - PLC Designer Frame
The 'Frame' plug-in provides for command category 'View' commands (see below)
which serve to define certain object properties resp. to switch on/off the full screen
mode.
By default these commands are part of the 'View'. If necessary open the Customize
dialog to view resp. modify the menu configuration (notice category 'View').
The commands:
• Full Screen
• Properties...
• Start Page
Properties...
Symbol:
This command (category 'View') opens dialog 'Properties '. The
properties of the currently selected object in the POUs or Devices view will be
displayed on various tabs, the availability of which depends on the type of object.
The following dialogs are possible:
Common (information on object)
Provides information on the object:
Full name: Object name as used in the POUs or Devices view
Object type: Type of the object (for example POU, Application, Interface etc.)
Open with: Type of the editor which is used to edit the object
Abb. 285 Properties dialog, Category Common