Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 433)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 431
Options, Libraries
This sub-dialog of the options dialog serves to manage the "mappings" of library
references which will be applied during the conversion of an "old" project. As long as
no mapping is stored for a particular library here in the options dialog, you will be
asked for one each time when you open an old project including this library.
See Open Project for a description on opening and converting old projects.
See Library Management for a description on library management.
A "mapping" defines how the library reference should look after the conversion of the
project. There are three options:
• The library reference should be kept, that is the library gets converted to the new
format (*.library) and installed in the local library repository
• The library reference should be replaced by another one, that is one of the currently
installed libraries is selected to get included instead of the previous one.
• The library reference should be removed, the library will not be included in the
converted project.
If you decide to save the mapping, it will be added to the Options dialog in category
'Libraries':
Abb. 215 Options dialog, category Libraries
All mappings which are listed here, will be applied at the next conversion of an old
project and its library references. Thus you do not need to repeat the mapping
definition when the same library is referenced in multiple projects to be converted.