Options, »plc designer« v2.3 converter, L-force | plc designer – Lenze PLC Designer PLC Designer (R3-1) User Manual
Page 435

L-force | PLC Designer
Menu Commands sorted by Categories
DMS 4.1 EN 03/2011 TD29
433
12.23.2
Options, »PLC Designer« V2.3 converter
In this sub-dialog of the options dialog the "conversion mapping" for »PLC Designer«
V2.3 projects is defined.
Tab 'Devices' describes the conversion of the used devices (target systems):
As long as no "mapping" is stored for a particular device here in the options dialog, you
will be asked for one each time when you open an old project using this device.
See Open Project for a description on opening and converting old projects.
See Device, Device Tree for a description on device handling.
A "device conversion mapping" defines how the device reference should look after the
conversion of the project. That is it assigns a "Target device" (device in new project) to
the "Source device" (device in old project). There are two options:
• The source device will be replaced by the target device, that is another, currently
installed and device, in the device tree of the new project.
• The source device will not be converted (will be ignored), that is will not be
available in the device tree of the new project. Thus also application-specific
objects, like for example the task configuration, will not be transferred to the new
project.
A mapping can be defined and stored ...
• ... during the conversion of an appropriate (device-including) old project (see the
description of the 'Open Project' command)
• ... or it can be directly entered in the converter options dialog in the Devices tab:
Abb. 217 Options dialog, category »PLC Designer« 2.3 converter