Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 892)

L-force | PLC Designer
Device Editors
890 DMS 4.1 EN 03/2011 TD29

CANopen I/O Mapping
This dialog is only available in the CANopen device configuration of a non-modular
device. It is the standard Device Editor dialog for the configuration of the I/O-mapping
of a module, that is for assigning IEC variables to input and output channels of the
hardware.
Status
This tab of the configuration editor for an CANbus device or module provides status
information (for example "Running", "Stopped") and device-specific diagnostic
messages, also on the used card and the internal bus system.
Information
This dialog in the CANopen device or module configuration shows information on the
device resp. module which is currently selected in the devices tree. If available for the
current module, the following general information will be displayed: Name, Vendor,
Type, Version number, Categories, Order Number, Description, Image.
CANopen module
CANopen-Module Configuration
This is the standard dialog of the device editor for handling the parameters of the
currently selected CANopen module, which is part of a CANbus configuration.