Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 536)

L-force | PLC Designer
Menu Commands sorted by Categories
534 DMS 4.1 EN 03/2011 TD29

Instance path Complete object path of the breakpoint
position example:
"PLC.Application.PLC_PRG.FBinst1"
Tasks Tasks during the run of which the
breakpoints should be noticed: "(any)" in
case of no restriction (default), resp.
particular task name(s) . example: "MainTask, SubTask1"
Condition Definition of when (number of hits) the
breakpoint should cause a break in
processing; (default: 1). example: "Break when the hit count
is equal to 3"
Current hit count Indicates how often the breakpoint has
been run through (hit) up to now. example: "3"
The following functions are available as buttons in the upper right part of the dialog
for editing the current breakpoints parameters resp. for removing or adding
breakpoints:
New breakpoint Opens the 'New breakpoint' dialog for defining a new breakpoint.
See description of corresponding command 'New breakpoint'.
Clear breakpoint Removes the breakpoint; do not mix up with disabling !
Enable/disable
breakpoint Toggles the breakpoint between 'enabled' and 'disabled' status; in
case of 'disabling' the breakpoint will not be removed from the list, but
can be re-enabled.
Properties Dialog 'Breakpoint Properties' will be opened, where you can modify the
breakpoint parameters. The dialog matches the 'New Breakpoint' dialog.
Go to source
position The 'Select Online State' dialog will open from where you can get to the
source position of the breakpoint.
Clear all
breakpoints Removes all breakpoints. The list will be empty. Do not mix up with
disabling!
Enable all
breakpoints Enables ( )all currently disabled breakpoints .
Disable all
breakpoints Disables ( ) all currently enabled breakpoints. The breakpoints remain in
the list and can be re-enabled.