Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 527)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 525
12.34.2 Add Visualelement
This command (category Visual Commands) by default is available in the Visualization
menu and in the context menu. It is used to insert an element into the current
visualization and thus corresponds to inserting via drag & drop from the visualization
Toolbox.
The command opens a submenu where from a list of all currently available
visualization elements one can be chosen. The selection matches that of the
visualization Toolbox.
12.34.3 Select all
This command (category Visual Commands) is used to select all visualization elements
of the current visualization at once. Notice also command Select none.
12.34.4 Select none
This command (category Visual Commands) is used to cancel at once any selection in
the current visualization.
12.34.5 Group
Symbol:
This command (category Visual Commands) groups the currently selected visualization
elements and displays the group as a single selected object. For multiple selection keep
the key pressed while clicking on the desired elements. Alternatively you might
perform a mouse-click outside of an element in the editor window and - while keeping
the mouse-button pressed - draw a rectangle around the desired elements.
For resolving the group use command Ungroup.
The following picture shows the grouping (from left to right) and ungrouping (from
right to left) of two rectangle elements:
Abb. 279 Grouping and ungrouping