Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 234)

L-force | PLC Designer
Menu Commands sorted by Categories
232 DMS 4.1 EN 03/2011 TD29

12.4.2 Cross References List
Browse Project commands - Cross Reference View
The 'Cross Reference View' plug-in provides commands concerning the cross references
list of a variable.
By default these commands are available in the Cross Reference View window.
The commands:
Browse Cross References
Go To Definition
Browse Cross References
Symbol:
This command (category Browse Project) dumps the cross reference list, which is
currently displayed in the Cross References List view, to the message view. This might
be of interest when the automatic cross reference listing is activated.
The command is also available via a button in the Cross Reference List View.
Go To Definition
Symbol: Shortcut:
This command (category Browse Project) effects a jump to the location, where the
variable, the reference of which is currently selected in the cross reference list, is
declared. The corresponding declaration editor will be opened and the variable will be
highlighted there.