Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 42)

L-force | PLC Designer
Lenze Specific Functions
40 DMS 4.1 EN 03/2011 TD29

Error messages
The following error messages have been stored:
Error message Description
411 TouchProbeSelect incorrect: TP channel does not exist
TouchProbeSelect > 1 in the case of ECSxM
TouchProbeSelect > 2 in the case of 9400
412 TouchProbeMode incorrect: Only the values 1 or 2 are permitted.
413 TouchProbeEdge incorrect: Only the values 1, 2 or 3 are permitted.
414 TouchProbeEdge incorrect: Requested edge evaluation does not exist
TouchProbeEdge > 2 in the case of ECSxM (Only positive or negative edge
possible.)
TouchProbeEdge > 4 in the case of 9400 (Type of edge evaluated not
supported.)
415 TP channel not free:
TP channel has already been activated by means of other block.
416 Touch probe is not possible for the currently selected process data
mapping.
417 Internal error / TP channel not free:
TP channel has already been activated by means of other block.
418 Internal error:
Timeout during assignment of the drive
419 Internal error: Communication error
421 TouchProbeSignal incorrect: Only the value 1 is permitted.
430 The FreeEncoder axis specified at the Axis input does not exist
431 The FreeEncoder axis specified at the Axis input is configured incorrectly
432 TouchProbeEdge selection incorrect
433 TouchProbeEdge selection incorrect