Maple Systems MAPware-7000 - Manual (Page 7)

MAPware-7000 Programming Manual vii
1010-1040, Rev. 02
Safety Precautions

Store in a cool, clean, and dry location. Avoid storage locations with extreme temperatures, rapid
temperature changes, high humidity, moisture, dust, corrosive gases, or metal particles.

Do not store the unit in places that are exposed to outside weather conditions (i.e., wind, rain,
snow, etc.).
Disposal
Never dispose of electrical components via incineration. Contact your state environmental agency for
details on disposal of electrical components and packaging in your area.
Installation Precautions
Location and Ambient Requirements
a) Adequate personnel working space and adequate illumination must be provided for adjustment,
inspection, and maintenance of the equipment.
b) Avoid installation in areas where vibration, heat, humidity, dust, fibers, steel particles,
explosive/corrosive mists or gases, or sources of electrical noise are present.
c) The installation location shall not be exposed to direct sunlight.
d) Allow proper clearance spaces for installation. Do not obstruct the ventilation openings. Refer to
the recommended minimum installation dimensions as shown on the enclosure outline
drawings.
e) The ambient operating temperature shall be between 0° and 50° C (32° and 122° F).
Mounting Requirements
a) Only Qualified Personnel should install this equipment.
b) Install the unit in a secure upright position in a well-ventilated area.
c) A noncombustible insulating floor or mat should be provided in the area immediately
surrounding the electrical system at the place where maintenance operations are to be
performed.
Conductor Routing and Grounding
a) Use separate metal conduits for routing the input power, and control circuits.
b) A separate ground cable should be run inside the conduit with the input power, and control
circuits.
c) DO NOT connect control terminal strip return marked CC to earth ground.
d) Always ground the unit to prevent electrical shock and to help reduce electrical noise.
The Metal Of Conduit Is Not An Acceptable Ground.