Maple Systems MAPware-7000 - Manual (Page 272)

272 MAPware-7000 Programming Manual
1010-1040, Rev. 02
Halt mode is useful if you wish to change values in the Data Monitor window but not
while the HMC is running the project you downloaded into it. However, the HMC will
clear all internal memory registers (except the retentive memory) when you place the
HMC in Run mode again.
To place the unit in Halt mode, click on the Halt icon in the standard toolbar. To
resume, click on the Run icon.

When you are finished using the Data Monitor mode, click on the Go Online button
(now Go Offline) again to go offline.
Note: you can add or edit the blocks listed in the Data Monitor window when online with the
HMC7000.
Application Memory Status
The Application Memory Status feature is a tool available in the MAPware-7000 software that is
used to display memory used by the current project. This tool can be used to determine how
much memory is still available for new screens, ladder logic, etc.:
It also provides details on how the screen memory is currently allocated. The memory is divided
into three main areas: