Maple Systems MAPware-7000 - Manual (Page 328)

328 MAPware-7000 Programming Manual
1010-1040, Rev. 02

Function Key LED button – each function key LED is lit for two seconds in sequence.
This is another visual test, so you must watch the LEDs come on as the HMC7000 states
that the LED is on.

Flash button – this is a non-destructive Flash memory test. This test splits the flash
memory into eight sections, testing each section in sequence. The total test takes about
3 minutes to complete:
It is important not to remove power during this test.

EEPROM button – another non-destructive memory test of the EEPROM.
It is important not to remove power during this test.

Backlight button – This is another visual test. The HMC7000 will shut off the LED
backlight for a few seconds, then turn it back on: