Maple Systems MAPware-7000 - Manual (Page 69)

MAPware-7000 Programming Manual 69
1010-1040, Rev. 02
c. Logged Data – uploads any data collected using the Data Logger feature (see
Chapter 8 – Data Logger and Trending “Upload to the MAPware-7000
software” section for more details).
d. Historical Alarm Data – uploads any alarm messages collected when using the
Historical Alarm feature (see Chapter 7– Alarms “How to upload historical
alarms” section for more details).
7. Click the Upload button:
C
Click OK.
8. When the upload is finished, click Close.
Downloading a project
1. Start the MAPware-7000 configuration software and open the project you wish to
download to the unit.
2. Connect to the HMC7000 using either a USB or RS232 serial download cable.
3. Apply power to the unit.
4. Click Project...Transfer…Download from the standard menu.
5. Under Mode, select Serial or USB connection.
6. Under Download Options (click the Options button if you do not see this
section), select what data you wish to download:
a. Firmware - the internal program inside the HMC7000 that makes it run. If you
are downloading:
i. to a new unit
ii. upgrading the firmware of the unit to a newer version
iii. a project that was created in an older version of MAPware-7000