Maple Systems MAPware-7000 - Manual (Page 313)

MAPware-7000 Programming Manual 313
1010-1040, Rev. 02
MW memory (IO registers)
Tag
No. Tag
Name
Tag
Address
Type Access Models
Supported
Description
1 PLC Operation
Mode MW0000 Register
(2 bytes) Read/
Write HMC7000
0 = Initialization
1 = Halt mode
2 = Run mode
3 = Run in Forced mode
4 = Hold mode
6 = Fault mode
Note: If an invalid number is
entered into this register,
then previous value will be
retained.
2 Run/Stop Switch
Control MW0003 Register
(2 bytes) Read/
Write HMC7000
0= Run
1 = Halt
Note: this value is stored in
retentive memory
3 Digital Filter
constant (0-
150msec) MW0005 Register
(2 bytes) Read/
Write PLC7000 Note: Entered value is
multiple of 10msec.
To enable, MW0010 bit 16
must be ON.
4
5 Ethernet IP
Address
(Low Word) MW0033 Register
(2 bytes) Read
Only PLC7008A-ME
only First six digits of the IP
address assigned to
PLC7000 (see
Define…Ethernet Settings
menu)
6 Ethernet IP
Address
(High Word) MW0034 Register
(2 bytes) Read
Only PLC7008A-ME
only Last six digits of the IP
address assigned to
PLC7000 (see
Define…Ethernet Settings
menu)
7 Subnet Mask
(Low Word) MW0035 Register
(2 bytes) Read
Only PLC7008A-ME
only First six digits of the subnet
assigned to PLC7000 (see
Define…Ethernet Settings
menu)
8 Subnet Mask
(High Word) MW0036 Register
(2 bytes) Read
Only PLC7008A-ME
only Last six digits of the subnet
assigned to PLC7000 (see
Define…Ethernet Settings
menu)
9 Default Gateway
(Low Word) MW0037 Register
(2 bytes) Read
Only PLC7008A-ME
only First six digits of the
gateway assigned to
PLC7000 (see
Define…Ethernet Settings
menu)