Maple Systems MAPware-7000 - Manual (Page 332)

332 MAPware-7000 Programming Manual
1010-1040, Rev. 02
Press the System Setup button on the MODE SELECTION MENU to enter the System Setup Mode
main screen:

TouchScreen Calibrate button – executes the touchscreen calibration screen:
Touch the crosshair symbol. The symbol will then move to the upper right corner; touch
it again. Unit will calibrate and reinitialize.

Com Port Settings button – this screen will allow you to configure the communication
parameters (i.e. baud rate, parity, etc) for each serial port.
Note: any serial parameters configured in the downloaded project take precedence over
these settings when the project is running.

RTC (real-time clock) Setting button – this screen is used to set the real-time clock in the
HMC.