Maple Systems MAPware-7000 - Manual (Page 188)

188 MAPware-7000 Programming Manual
1010-1040, Rev. 02

Span Time – if Time (sec) is selected above, enter the pre-defined length of time (range
is 0 to 65536) in seconds.

Span Time Tag Address (List Qa) if Tag Selected is chosen for Span above, this is the
address of target register continuously read by the HMC to determine the time span.
Time period is seconds and the value read must be in the range of 0 to 65535.

Span Time Tag Name – this is the name given to the span time tagged register in the Tag
Database.

Design (List S) – identifies object.

Layout (List T) – coordinates (i.e. size and position) for the object.

Tag Attributes section – use this section to configure the number of trend lines (target
tag addresses) and colors.

Number of Tags – this is the total number of tags or channels represented on the trend
graph. A channel is a line on the graph that represents the value of a target register at a
particular point in time. Range is 1 to 4 tags.

Selected Tag Color – this is the color of the channel line for the selected tag (see Tag
Selected below). Click on the
button to display the color palette and select a color.

Tag Address (List Qa) – this is the address of target register that is continuously read by
the HMC to determine the trend graph level.

Tag Name (List Qb) – this is the name given to the tagged register in the Tag Database.

Tag Selected – After Number of Tags is specified above, select each Tag from the pull-
down list box to configure the target Tag Address and color of the trend line.

Time Scale Properties section – determines the layout of the X time axis.

Format – select hours, minutes, seconds (HH:MM:SS) or hour, minutes (HH:MM).

Number of Grids – indicate the total number of grids that indicate time intervals (along
the x-axis) on the trend graph. Range is 1 to 10.

Scale – enable to display the time scale.

Scale Color - Click on the button to display the color palette and select a color to
display the time scale.

Value Scale Properties – sets the attributes for the Y-axis.

Maximum - options are Max or Tag. Select Max to configure a pre-defined maximum
value range on the trend graph. Use Tag to configure a PLC target address continuously
read by the HMC to determine the maximum range used by the trend graph.

Maximum Value – enter the maximum value when read from the target register
indicates the highest point on the trend graph.

Maximum Tag Address (List Qa) this is the address of target register continuously read
by the HMC to determine the maximum range.

Maximum Tag Name (List Qb) – this is the name given to the tagged register in the Tag
Database.

Minimum - options are Min or Tag. Select Min to configure a pre-defined minimum
value range on the trend graph. Use Tag to configure a PLC target address continuously
read by the HMC to determine the minimum range used by the trend graph.

Minimum Value – enter the minimum value when read from the target register
indicates the lowest point on the trend graph.

Minimum Tag Address (List Qa) this is the address of target register continuously read
by the HMC to determine the minimum range.

Minimum Tag Name (List Qb) – this is the name given to the tagged register in the Tag
Database.