Maple Systems MAPware-7000 - Manual (Page 267)

MAPware-7000 Programming Manual 267
1010-1040, Rev. 02
By default, the monitor shows a block of ten registers in the Timer (T) memory. To create or
edit additional blocks of memory, right click anywhere on the Data Monitor window to display a
popup dialog box:
Create a New Block
By clicking on the New Block option in the dialog box above, the following is displayed:

Address: Use the Address pull-down box to select the area of memory (see Appendix A-
Internal Memory Address for more information on internal memory). In the numeric
entry box, enter the starting address of the memory selected.

Size: this number represents the block of memory (registers) monitored. For example, if
D0 is entered into the Address section and 16 is entered in Size, the Data Monitor will
show a range of addresses from D0 to D15.

Data Type: this option varies according to the memory area selected. When available,
select how the data is interpreted and displayed in the Data Monitor window. Options
are Signed, Unsigned, and Hexadecimal.

Data Size: each register monitored can be a bit, (i.e. B memory), 2 bytes, or 4 bytes.

Color: you can display the block of memory using a particular color.

Click OK to add the block.