Maple Systems MAPware-7000 - Manual (Page 205)

MAPware-7000 Programming Manual 205
1010-1040, Rev. 02
Switch to Next Data Entry Moves to next Bit/Register Entry object according to Object
ID number
Switch to Previous Data Entry Moves to prior Bit/Register Entry object according to Object
ID number
Increase Value by 1 Adds +1 to the existing value
Decrease Value by 1 Subtracts -1 from the existing value
Increase Digit by 1 Adds +1 to the highlighted digit of existing value. If highest
digit value already shown, then cycles back to lowest digit
value
Decrease Digit by 1 Subtracts -1 from the highlighted digit of existing value. If
lowest digit value already shown, then cycles back to highest
digit value
Shift Value to Left Shifts value one digit to the left (same as multiplying by 10)
Move Cursor to Left Shifts focus cursor one digit to the right
Move Cursor to Right Shifts focus cursor one digit to the right
Sign Key (+/-) Toggles signed value
Sign Key (+/-) and 0 Toggles signed value when pressed once. Changes to 0 when
pressed again
Numeric keys 0-9 and A-F Enters specified numeral into entry field
Edit Bit On Changes Bit Entry value to 1
Edit Bit Off Changes Bit Entry value to 0
Acknowledge Alarm Acknowledges the top-most alarm displayed
Acknowledge All Alarms Acknowledges all currently active alarms
Previous Alarms Move all alarms down one line in the list of alarms
Next Alarm Move all alarms up one line in the list of alarms
Previous Historical Alarm Move all alarms down one line in the list of historic alarms
Next Historical Alarm Move all alarms up one line in the list of historic alarms