Appendix h fluor-s max multiimager, Appendix h, Fluor-s – Bio-Rad Quantity One 1-D Analysis Software User Manual
Page 356: Max multiimager

H-1
Appendix H
Fluor-S
MAX MultiImager
Fig.H-1. Fluor-S MAX MultiImager.
Before you can begin acquiring images using the Fluor-S
®
MAX MultiImager, the
imaging system must be properly installed and connected with the host computer. See
the Fluor-S MAX hardware manual for installation, startup, and operating
instructions.
Note:
Make sure that the temperature light on the Fluor-S MAX is green before
attempting to capture an image. If you are using a PC, the Fluor-S MAX should
be turned on and the initialization sequence completed before the host computer
is turned on. See the hardware manual for more details.
This manual is related to the following products: