Bio-Rad Quantity One 1-D Analysis Software - Manual (Page 160)

Chapter 6. Standards and Band Matching
6-17
Manually match bands until all the bands in the image are identified. The gel should
have no yellow (unknown) bands, and the modeling lines should intersect at or near
the middle of the bands across the gel. If the modeling lines are not parallel, the lanes
may be warped or distorted and thus difficult to compare using the automatic analysis
features.
6.2.b Band Set Dialog
The Band Set dialog contains the values of all the experimental bands in a gel, a tool
bar for band matching, and other information about the bands.
To open the dialog, select Matched Band Set from the Match menu or toolbar and
click anywhere on the image.
The dialog will open with a default name for the band set (e.g., Band Set 1). Enter a
new name at the top of the dialog, and add any comments or category/attribute
information you want to associate with the band set.