Lenze 8400 motec - Manual (Page 90)

5 Motor control (MCTRL)
5.3 Selecting the control mode
90 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.3 Selecting the control mode
The 8400 motec controller supports various modes for motor control (open loop or closed loop).
• The V/f characteristic control (VFCplus) is preset with a linear characteristic.
• The control mode can be selected in the »Engineer« on the Application parameter tab via the
Motor control ( C00006 ) list field:
• A click on the Motor control... button leads you to the parameterisation dialog of the selected
motor control. (The button is labelled according to the selected motor control.)

Tip!
In order to make the selection of the motor control easier, we provide a selection help with
recommendations and alternatives for standard applications in the subchapter entitled
" Selection help ". ( 93)
The following section briefly describe the control modes. A reference to more details can be found
at the end of each section.