Lenze 8400 motec - Manual (Page 339)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 339
11 Parameter reference
11.2 Parameter list | C00024
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00024
C00026
C00027
Parameter | Name:
C00024 | Comparison value N_Act
Data type: INTEGER_16
Index: 24551 d = 5FE7 h
Threshold for the actual speed comparison
• This parameter serves to set a threshold that is compared with the actual speed value.
• If the value falls below this threshold, the bNactCompare output sets the LS_DriveInterface system block to
TRUE.
• Switching hysteresis = +1 %
Setting range (min. value | unit | max. value) Lenze setting
0.0 % 199.9 0.0 %
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00026 | AINx: Offset
Data type: INTEGER_16
Index: 24549 d = 5FE5 h
Offset for analog inputs
 Analog terminals
Setting range (min. value | unit | max. value)
-199.9 % 199.9
Subcodes Lenze setting Info
C00026/1 0.0 % AIN1: Offset
C00026/2 0.0 % AIN2: Offset
• From version 04.00.00
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00027 | AINx: Gain
Data type: INTEGER_32
Index: 24548 d = 5FE4 h
Gain for analog inputs
 Analog terminals
Setting range (min. value | unit | max. value)
-199.9 % 199.9
Subcodes Lenze setting Info
C00027/1 100.0 % AIN1: Gain
C00027/2 100.0 % AIN2: Gain
• From version 04.00.00
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100