Lenze 8400 motec - Manual (Page 410)

11 Parameter reference
11.2 Parameter list | C00999
410 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00999
C01000
C01082
Parameter | Name:
C00999 | SLPSM: PLL gain
Data type: INTEGER_16
Index: 23576 d = 5C18 h
From version 03.00.00
 Sensorless control for synchronous motor
Setting range (min. value | unit | max. value) Lenze setting
0 % 1000 50 %
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C01000 | MCTRL: Status
Data type: UNSIGNED_16
Index: 23575
d
= 5C17
h
From version 03.00.00
Display area (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded:
Bit 0 SL PSM: Mode
Bit 1 Reserved
Bit 2 Reserved
Bit 3 Reserved
Bit 4 Reserved
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C01082 | LS_WriteParamList: Execute Mode
Data type: UNSIGNED_8
Index: 23493 d = 5BC5 h
Parameter change-over : Selection of the activation method
Selection list (Lenze setting printed in bold) Info
0 by Execute The writing of the parameter list is activated by a FALSE/
TRUE edge at the bExecute input.
1 by Input Select The parameter list is written if a change is made at the
bSelectWriteValue_1 selection input and once when the
controller is initialised.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1