Lenze 8400 motec - Manual (Page 61)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 61
4 Device control (DCTRL)
4.1 Device commands (C00002/x)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Short overview of device commands
Activate device command
When an online connection has been established, simply use the »Engineer« to activate a device
command by selecting the corresponding option from the Parameters tab in C00002/x ("0: off" or
"1: On / start").
• Alternatively, the device command can also be activated via e.g. keypad or through a master
control by writing to C00002/x .
• Some of the frequently used device commands (such as "Save parameter set") can also be exe-
cuted via the Toolbar icons of the »Engineer« when an online connection has been established:
C00002
Subcode:
Device command Controller inhibit re-
quired
Status information
1 Load Lenze setting  dynamic
2 Load parameter set 1  dynamic
7 Save parameter set 1
 Save parameter settings
dynamic
11 Save all parameter sets
 Save parameter settings
dynamic
12 Importing EPM data static
16 Enable/Inhibit controller static
17 Activate/deactivate quick stop static
19 Reset error static
21 Delete logbook static
23 Motor parameter identification  dynamic
26 CAN reset node static
27 Device search function
(from version 04.00.00)
static
* Subcodes which are not listed are reserved for future extensions.
Icon Function
Enable controller
Inhibit controller
Save parameter set (for 8400: Save all parameter sets)
Device search function
(from version 04.00.00)

Note!
Device commands that can be executed via the Toolbar of the »Engineer« always affect
the element currently selected in the Project view including all subelements!
• If no controller but e.g. a system module is selected in the Project view instead, the cor-
responding device command will be activated in all lower-level controllers that have
an online connection to the »Engineer«.
Before the desired action is carried out, a confirmation prompt appears first, asking
whether the action is really to be carried out.