Lenze 8400 motec - Manual (Page 76)

4 Device control (DCTRL)
4.2 Device state machine and device states
76 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.7 Trouble
In the "Trouble" device state
• is the controller if monitoring has caused a "Trouble" error response.
• the motor has no torque (is coasting) due to the inhibit of the inverter.
Depending on certain conditions a status change takes place based on the "Trouble" device status.
Related topics:
 wDriveControl control word ( 211)
 Basics on error handling in the controller ( 283)
 Error messages of the operating system ( 297)
LED status display Display in C00137 Display in status word 1 ( C00150 )
Bit 11 Bit 10 Bit 9 Bit 8
Trouble 0 1 1 1

Note!
The "Trouble" device status is automatically abandoned if the error cause has been re-
moved.
If in
C00142 the "Inhibit at trouble" is activated, explicit deactivation of the controller in-
hibit is required before this status can be abandoned.
Change condition Changeover to the device status
The error cause is no longer active. ReadyToSwitchOn
Control bit "EnableOperation" in control word wDriveControl = "1"
AND terminal RFR = HIGH level (controller enable)
AND the message has been cancelled.
OperationEnabled
Control bit "EnableOperation" in control word wDriveControl = "0"
OR terminal RFR = LOW level (controller inhibit)
AND the message has been cancelled.
SwitchedOn