Lenze 8400 motec - Manual (Page 264)

8 Basic functions
8.1 Parameter change-over
264 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Creating/changing the list

To create or change the list, proceed as follows:
1. Click on Change list button.
• The dialog box entitled Configure WriteParamList is shown:
• On the left-hand side, all the parameters of the drive controller with write and read
access are shown in the list entitled Available parameters.
• If the option In menu groups is activated, all parameters are shown assigned to their
functions.
• By clicking on the button in the Filter area, you can shorten the list of available
parameters. If, for example, you enter the text "ain1" and then click on the button, only
those parameters whose designation contains this text are shown for selection.
2. Highlight the parameter/parameters in the Available parameters list that is/are to be
added to the WriteParamList.
• Here, you can use the <Ctrl> key and the<Shift> key for multiple selection, as in the case
of general Windows functions.