Lenze 8400 motec - Manual (Page 445)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 445
12 Function library
12.2 L_NSet_1
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12.2.1 Main setpoint path
• The signals in the main setpoint path are limited to a value range of ±32767.
• The signal at nNSet_a is first led via the JOG selection function.
• A selected JOG value switches the nNSet_a input inactive. Then, the subsequent signal
conditioning operates with the JOG value.
12.2.2 JOG setpoints
In addition to the direct main setpoint selection via the nNSet_a input, so-called JOG setpoints can
be preset in C00039/1...3 .
• The JOG setpoints are binary-coded and can be called using the bJog1 and bJog8 selection
inputs:
• The number of selection inputs to be assigned depends on the number of JOG setpoints
required.
12.2.3 Setpoint inversion
The output signal of the JOG function is led via an inverter.
The sign of the setpoint changes if bNSetInv is set to TRUE.
C00634 Status (bit-coded)
• Bits that are not listed are
reserved for future extensions.
Bit 0 No blocking zone active
Bit 1 Blocking zone 1 active
Bit 2 Blocking zone 2 active
Bit 3 Blocking zone 3 active
Bit 4 Jog in blocking zone
Bit 5 MaxLimit active
Bit 6 MinLimit active
Parameter Possible settings Info
Selection inputs Used main setpoint
bJog2 bJog1
FALSE FALSE nNset_a
FALSE TRUE C00039/1
TRUE FALSE C00039/2
TRUE TRUE C00039/3