Lenze 8400 motec - Manual (Page 355)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 355
11 Parameter reference
11.2 Parameter list | C00137
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00137
C00141
Parameter | Name:
C00137 | Device status
Data type: UNSIGNED_16
Index: 24438 d = 5F76 h
Display of the current device status
Selection list
(read only)
0 Reserved
1 Init
2 MotorIdent
3 ReadyToSwitchON
4 SwitchedON
5 OperationEnable
6 Reserved
7 Trouble
8 Fault
9 Reserved
10 SafeTorqueOff
11 Reserved
12 Reserved
13 Reserved
14 Reserved
15 Reserved
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00141 | Device settings
Data type: UNSIGNED_8
Index: 24434 d = 5F72 h
Selection list
0 Inactive
1 Active
Subcodes Lenze setting Info
C00141/1 0: Inactive Always save parameters
• When this function is activated, every parameter
change is saved in the memory module. A manual
saving of parameter sets is not required anymore.
Note:
Activating this function is not permissible if parameters
are changed very frequently (e.g. in case of cyclic writing
of parameters via a bus system).
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1