Lenze 8400 motec - Manual (Page 315)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 315
9 Diagnostics & error management
9.8 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
dF10: time out I/O micro [xx.0145.00010]
dF11: oscillator fail [xx.0145.00011]
dF12: math error [xx.0145.00012]
dF13: DMA error [xx.0145.00013]
IoC: Comm module changed [xx.0145.00198]
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Device error • Make sure that the Drive Unit and the Communica-
tion Unit are connected correctly to each other. Check
the pins of the COM plug and firmly tighten all screws
of the 8400 motec cover.
• Mains switching or restart of the controller, respec-
tively.
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Device error • Mains switching or restart of the controller, respec-
tively.
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Device error • Mains switching or restart of the controller, respec-
tively.
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Device error • Mains switching or restart of the controller, respec-
tively.
• Please contact Lenze if the problem occurs again.
Response (Lenze setting printed in bold)
 No Reaction  Fault  Trouble  WarningLocked
Cause Remedy
Since the last power-down, the Communication Unit has
been replaced. The fieldbus, the safety circuit or the
module type has changed. It cannot be assumed any-
more that the available parameter setting matches the
new Communication Unit.
Switch off the device and mount the previous Communi-
cation Unit again. Then acknowledge the error with the
C00002/19 = "1: On / start" device command. All com-
munication parameters in the device will be set to the
Lenze setting of the currently used Communication Unit.
Changed communication parameters must be reset and
saved.