Lenze 8400 motec - Manual (Page 371)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 371
11 Parameter reference
11.2 Parameter list | C00246
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00246
C00273
C00276
C00290
C00291
C00292
C00293
Parameter | Name:
C00246 | L_PCTRL_1: nAct_a internal
Data type: INTEGER_16
Index: 24329 d = 5F09 h
From version 04.00.00
FB L_PCTRL_1 : Display of the internal actual value
Display range (min. value | unit | max. value)
-199.9 % 199.9
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00273 | SC: Moment of inertia
Data type: UNSIGNED_16
Index: 24302
d
= 5EEE
h
From version 03.00.00
Moment of inertia for setpoint feedforward control with sensorless vector control ( SLVC )
Setting range (min. value | unit | max. value) Lenze setting
0.0 kg cm^2 6000.0 0.0 kg cm^2
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10
Parameter | Name:
C00276 | SC: Max. output voltage
Data type: UNSIGNED_8
Index: 24299 d = 5EEB h
From version 04.00.00
Setting range (min. value | unit | max. value) Lenze setting
80 % 99 95 %
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00290 | Module type
Data type: UNSIGNED_16
Index: 24285 d = 5EDD h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00291 | Module software compatibility value
Data type: UNSIGNED_16
Index: 24284 d = 5EDC h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00292 | Drive internal communication status
Data type: UNSIGNED_8
Index: 24283 d = 5EDB h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00293 | Module internal communication status
Data type: UNSIGNED_8
Index: 24282 d = 5EDA h
This code is for device-internal use only and must not be written to by the user!