Lenze 8400 motec - Manual (Page 22)

2 Introduction: Parameterising the controller
2.3 General notes on parameters
22 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.3.1 Changing the parameterisation with the keypad
Simply connect the diagnosis terminal to the diagnostic interface being located on the top of the de-
vice.
• The connecting cable can also be connected to the diagnostic interface during operation and re-
moved again.
Keypad display and control elements
LCD display
Headline
In the menu level: Menu name
In the parameter level: Parameter name
Three-part display
In the menu level: List of available menus
In the parameter level: Code/subcode and setting or actual value
Device status
 Controller is switched on  Pulse inhibit active
 Controller is enabled  System fault active
 Controller is inhibited  "Fault" device status is active
 Quick stop active  "Trouble" device status is active
 Current limit exceeded  "TroubleQSP" device status is active
 Speed controller 1 in the limitation  A warning is indicated
Function - left function key Function - right function key
 Change parameter setting
(change to editing mode)
 Accept change in the controller
(no saving with mains failure protection   )
 Back to main menu  Abort (discard change)
 Parameter can only be changed when the controller is inhibited
 Save all parameter settings in the memory module safe against mains failure
WXST VYR
+HDGOLQH
7ULSOHOLQHGLVSOD\
&XUUHQWIXQFWLRQ
ULJKWIXQFWLRQNH\ &XUUHQWIXQFWLRQ
OHIWIXQFWLRQNH\
/&'GLVSOD\
'HYLFHVWDWH
,QPDQXDOFRQWUROPRGH
6WDUWPRWRU ,QPDQXDOFRQWUROPRGH
6WRSPRWRU