Lenze 8400 motec - Manual (Page 33)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 33
3 Commissioning
3.4 Commissioning wizard 8400
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.4 Commissioning wizard 8400
This function extension is supported by the »Engineer« from version 2.15 onwards!
The commissioning wizard 8400 serves to carry out a guided commissioning of the controller based
on the Lenze setting of the parameters. The set parameters can then be saved in the controller with
mains failure protection.

How to carry out a guided commissioning using the »Engineer«:
1. In the Project view, select the 8400 motec controller.
2. Go online.
• After a connection to the controller has been established, the following status is
displayed in the Status line:
3. Click the icon to open the commissioning wizard 8400 dialog box.
• Now the commissioning wizard guides you step by step through the setting of the
important parameters for a quick commissioning.
• The Next button can only be activated again after all parameter settings in the device
have been reset via the Load Lenze setting button.

Note!
Take all the necessary safety precautions before you carry out the following
commissioning steps and switch the device on!
 Safety instructions with regard to commissioning ( 31)