7 reset error, 8 delete logbook, Reset error – Lenze 8400 motec User Manual
Page 66: Delete logbook, 4device control (dctrl)
4
Device control (DCTRL)
4.1
Device commands (C00002/x)
66
Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.1.7
Reset error
The
= "1: On / start" device command acknowledges an existing error message if the er-
ror cause has been eliminated and thus the error is not pending anymore.
• After the reset (acknowledgement) of the current error, further errors may be pending which
must also be reset.
• The status-determining error is displayed in
.
Tip!
An error message can also be acknowledged by activating the Reset error button in the Di-
agnostics tab.
In the Lenze setting, switching RFR causes also causes an error acknowledgement (see con-
).
Detailed information on error messages can be found in chapter entitled "
".
4.1.8
Delete logbook
The
= "1: On / start" device command deletes all logbook entries.
Tip!
Click the Logbook button in the Diagnostics tab to display the Logbook in the »Engineer«.
In the Logbook dialog box, it is also possible to delete all Logbook entries by clicking the De-
lete button.
Detailed information on the logbook can be found in the chapter entitled "