Firmware, Actions, Abort – HP Integrity NonStop J-Series User Manual
Page 89: Firmware update, Responsive test, Start, Abort firmware update responsive test start

Indication of whether the ATM adapter software is automatically dumped to the specified
dump file if the software abends abnormally.
Enabled: The software is automatically copied.
Disabled: The software is not automatically copied.
Unknown:: The Automatic Dump state could not be read.
Automatic Dump State
The type of media or cable, such as single-mode fiber or coaxial cable, supported by
the ATM CRU.
Media Type
Indication of whether the ATM CRU firmware is automatically updated when the ATM
CRU is started. The automatic firmware update occurs if either the Start action is performed
through the OSM software or the START ADAPTER command is issued from SCF.
Enabled: The firmware is automatically updated.
Disabled: The firmware is not automatically updated.
Unknown:: The Automatic Firmware Update state could not be read.
Automatic Firmware Update
The state of the component as known to the operating system on the server.
Device State
Indication of whether the ATM CRU software is automatically reloaded if the adapter
software terminates abnormally.
Enabled: The software is automatically reloaded.
Disabled: The software is not automatically reloaded.
Unknown:: The Automatic Reload state could not be read.
Automatic Reload State
The name of the file used to download the ATM CRU adapter.
Download Filename
The currently available processors that can access the adapter.
Processor Access List
Firmware
The version of the firmware running on the ATM CRU.
Version
The name of the file to be used for a firmware update.
Default Firmware Filename
The version of the firmware to be used for a firmware update.
Default Firmware File
Version
Indication of the differences, if any, between the current and default firmware versions.
Compare State
Actions
Abort
Terminates operation of the ATM CRU and the associated ATM line. When the Abort action finishes,
the ATM CRU and the ATM line are in the Stopped state.
Firmware Update
Updates the ATM adapter firmware.
Responsive Test
Verifies that the component is connected and responding.
Start
Starts the ATM CRU and the associated ATM line. The ATM CRU must be in the Stopped state
before you perform this action.
During startup, the controller operational code is automatically loaded into the ATM CRU. When
the Start action finishes, the ATM CRU and the ATM line are in the Started state.
ATM3SA (ATM Adapter)
89