Set led state, Show smartssd wear gauge, Start disk – HP Integrity NonStop J-Series User Manual
Page 126: Start volume, Stop disk, Dvd-rom (blade element), Attributes, Dvd-rom, Physical, Actions

Set LED State
Sets the LED on the physical disk in the SAS disk enclosure to On or Off.
Show SMARTSSD Wear Gauge
This action is available for Solid State drives only. It displays the current SMARTSSD Wear Gauge
values, which includes estimates for both the amount of life used up for the disk and for the amount
of life remaining. A disk with a low percentage of life used can display an unusually high number
of hours of life remaining.
The
Get SMARTSSD Wear Status Summary
guided procedure on the System object allows you to
display the same information for multiple (any or all selected) drives in a single interface and to
save the resulting data in .csv (or comma delimited) format for use in Microsoft Excel.
Start Disk
Starts all partitioned and non-partitioned paths to this disk drive.
Start Volume
Starts all partitioned and non-partitioned paths for both the primary and mirror drives of this volume.
Stop Disk
Stops all partitioned and non-partitioned paths to this disk drive.
DVD-ROM (Blade Element)
In the OSM Service Connection, an object displayed as a subcomponent under the
object for Integrity NonStop NS1000, NS1200, NS5000, and NS3000AC servers only.
Attributes
DVD-ROM
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Service State
Physical
The part number of the component that was assigned in manufacturing. Use
part numbers for identifying and ordering parts.
Part Number
Actions
None
E4SA (Ethernet 4 ServerNet Adapter)
An adapter that connects the ServerNet connections inside a server to an Ethernet local area
network (LAN). The Ethernet 4 ServerNet Adapter (E4SA) CRU contains two Ethernet ServerNet
addressable controllers (SACs), each of which contains two Ethernet physical interfaces, for a total
of four Ethernet ports on each E4SA CRU.
This Nonstop S-series component can be connected to a Nonstop NS-series system through an
IOMF2 enclosure.
Location in OSM Tree: System > Group > Module > E4SA
Slot Location: E4SA CRUs can be located in slots 51, 52, 53, and 54 in IOMF2 enclosures (service
side).
126
System Resources