HP Integrity NonStop J-Series - Manual (Page 254)

Compare State (Other)
Meaning Value
Current and default versions are the same. Same
The current version is newer than the default version. Up-rev
The current version is older than the default version. Down-rev
Unable to compare files. Unknown
Device State
Meaning Value
Processing is terminating. Aborting
The device is currently not powered by either AC or UPS. AC Power Loss
State is defined by the NonStop OS. Defined
Performance is degraded. Degraded
A diagnostic test is running on the component. Diagnose
Processing is starting up. Initializing
State is not available to OSM. Not Available
The component is not configured. Not Configured
The component is not installed. Not Installed
Component is accessible. OK
The device is powered on. On
Predictive Failure
The component is running. Started
Processing is starting up. Starting
Processing has been terminated. Stopped
Processing is being terminated. Stopping
Component is not responding. Unknown
Enabled State
Meaning Value
The component is present but not operational, possibly because the Disable action was
performed. Disabled
The component is operational. Enabled
A problem was detected. The component might be functioning below standard or not
responding. Inspect the component. Fault
The component is not functional. Off
The component is functional. On
State is unknown; component might not be responding. Unknown
254 System Resources