Deleting alarms, Delete, Suppression persistence – HP Integrity NonStop J-Series User Manual
Page 69

Select, then right-click an alarm in the Alarms tab, Alarms dialog box, or the Alarm Summary
dialog box and click either Permanent or Temporary suppression, as desired:
•
If you select Permanent suppression and the same alarm is generated again on this object at
a later time, state propagation will not occur.
•
If you select Temporary suppression and the same alarm is generated again on this object at
a later time, state propagation will occur.
To undo the alarm suppression, select the alarm, right-click and choose Unsuppress.
Suppression Persistence
With OSM T0682 H02 ABX and later, suppression of state propagation resulting from alarms and
problem attributes is set, by default, to persistent. That is, the suppression that was specified in the
OSM Service Connection will remain in effect even after cold loads or restarting the OSM server.
To disable this persistence and make all suppression valid only for the current OSM server session,
see the OSM Configuration Guide for the necessary OSMCONF parameters.
Deleting Alarms
To delete an alarm, right-click the alarm in either the Alarms tab, Alarms dialog box, or the Alarm
Summary dialog box and select Delete. (In the Alarms dialog box or the Alarm Summary dialog
box, you can also highlight the alarm and click the Delete button.)
Deleting Alarms
69