HP Integrity NonStop J-Series - Manual (Page 281)

Hard Reset
Is necessary following a Configuration Update action in order for the changes to take effect.
CAUTION: This action disrupts the ServerNet traffic through this switch.
SCF Equivalent: SCF RESET SWITCH $ZZSMN, NEAREST { X | Y }, HARD
Prepare to Replace
Must be performed from each node of a ServerNet cluster before replacing a ServerNet II Switch
for SANMAN to accept the new switch.
Replace
Launches the guided procedure for replacing a ServerNet II Switch.
Set Fabric Setting
Sets the fabric LED indicator for the ServerNet II Switch to either X or Y.
Within three minutes after the action completes, the SANMAN process running on each of the
nodes discovers that the fabric setting has been corrected and accepts the new switch.
Parameter: Fabric Setting can be set to Unknown, Clear, X,or Y.
SCF Equivalent: SCF ALTER SWITCH $ZZSMN, NEAREST { X | Y }, FABRIC { X| Y }
Soft Reset
Used following a Firmware Update action on the switch for the changes to take effect.
SCF Equivalent: SCF RESET SWITCH $ZZSMN, NEAREST { X | Y }, SOFT
Switch Fan
A component that circulates air into the enclosure to help maintain optimal temperature.
Location in OSM tree: External ServerNet Fabric > Switch Group > Switch Module > Switch Fan
Example: Fan (1020.1.16)
Attributes
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Values
Service State
Physical
The state of the fault LED on the fan.
Values: On, Off, Blinking LED State
Whether the fan is installed and responding.
Values: Present, Absent, Unknown Presence
Logical
The initial state of the component at the time of discovery.
Enabled: The component is operational.
Disabled: The component is present but not operational, possibly because
the Disable action was performed.
Enabled State
Indication of whether the fan has a fault.
Values: OK, Fault Device State
Switch Fan 281