Attributes, Unknown cru, Physical – HP Integrity NonStop J-Series User Manual
Page 244: Actions, Unknown cru physical, Ups physical
Attributes
Unknown CRU
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Service State
Physical
Whether the component is powered on.
Power State
Actions
None.
UPS
Uninterruptible power supply (UPS) unit that provides backup power for Nonstop NS-series
enclosures.
Location in OSM Tree: System > Monitored Service LAN Devices > UPS
Example: UPS SDUPS
Attributes
UPS
Displayed in the Attributes tab and Attributes dialog box only if the value is something
other than OK.
Service State
Physical
Indicates the current status of the UPS battery. Possible values are Normal and On Battery.
OSM displays a yellow alarm if the UPS goes On Battery (or starts drawing power from
the battery). This alarm goes away when the UPS stops drawing power from the battery.
OSM displays a red alarm when the battery power is low.
Battery Status
Indicates whether the UPS is up or down.
Device Status
Version of the firmware on the UPS SNMP card.
Firmware Version
The IPv4 address of the UPS.
IPv4 Address
The model number of the UPS that was assigned in manufacturing.
Model
The unique number assigned to the UPS in manufacturing. Knowing the serial number is
especially helpful when you need to replace batteries or required other service.
Example: TU321A1185
Serial Number
Displays the version of the UPS software.
Software Version
Displays the physical location of the UPS as set by the super-user in the
action.
UPS Location
This is the apparent power rating of the UPS, expressed in Volt-Amperes.
Example: 12000 VA
VA Rating
244 System Resources