HP Integrity NonStop J-Series - Manual (Page 137)

Reset Disk
Places the disk in a state from which it can be started. This action might be necessary if the disk
was in a STOPPED state, substate HARDDOWN; a hardware error has occurred; the disk was
stopped with an ABORT command; or a STOP or ABORT fails to put the disk into the STOPPED
state, substate DOWN.
Reset Primary Path
Places the primary path in a state from which it can be started.
Reset Volume
Places the volume in a state from which it can be started.
Responsive Test
Verifies that the disk drive is installed and responding.
Start Backup Path
Starts the backup path to this disk drive. When the Start action completes, the backup path is in
the started State.
Start Disk
Starts all paths to this disk drive. When the Start action completes, all paths are in the Started state.
Start Primary Path
Starts the primary path to this disk drive. When the Start action completes, the primary path is in
the Started state.
Start Volume
Starts all paths for both the primary and mirror drives of this volume.
Stop Backup Path
Terminates operation of the backup path to the disk. When the Stop action finishes, the path is in
a Down state. If the disk drive is currently in use, a dialog box warns you and asks whether or not
you want to continue with the action.
Stop Disk
Terminates all paths for this disk drive. When the Stop action finishes, the paths are in a Down
state. If the disk drive is currently in use, a dialog box warns you and asks whether or not you
want to continue with the action.
Stop Primary Path
Terminates the primary path to the disk. When the Stop action finishes, the path is in a Down state.
If the disk drive is currently in use, a dialog box warns you and asks whether or not you want to
continue with the action.
Stop Volume
Terminates all paths for the primary and mirror drives of this volume. When the Stop action finishes,
the paths are in a Down state.
Switch to Backup Path
Switches processing from the primary to the backup path.
External Disk 137