HP Integrity NonStop J-Series - Manual (Page 88)

Actions
Link to Web Interface
Opens a Web interface that provides detailed device configuration and information for the alarm
panel.
Rediscover
Causes OSM to refresh and reanalyze the object. Refresh refers to OSM updating the attribute
values displayed in the OSM Service Connection interface. Reanalyze refers to the running of
OSM incident analysis, which checks EMS event messages and creates alarms in OSM if certain
conditions exist.
Stop Monitoring
Stops OSM from monitoring the alarm panel.
ATM3SA (ATM Adapter)
A customer-replaceable unit (CRU) that connects the ServerNet SAN inside a server to an
Asynchronous Transfer Mode (ATM) network through a logical connection known as an ATM line.
Each ATM CRU contains one
ATM line .
This Nonstop S-series component can be connected to a Nonstop NS-series system through an
IOMF2 enclosure.
Slot Location:ATM CRUs can be located in slots 51, 52, 53, and 54 in IOMF or IOMF2 enclosures
(service side).
Example: ATM3SA (12.1.53)
Attributes
ATM3SA
Displayed in the Attributes tab and Attributes dialog box only if the value is something
other than OK.
Values
Service State
Physical
A code that identifies the generation of the component. Hardware revision codes are
used for tracking components. Hardware Revision
Identifies the manufacturer of the component. Manufacturer
The part number of the component that was assigned in manufacturing. Use part numbers
for identifying and ordering parts. Part Number
Indication of whether the component is powered On or Off. Power State
A unique serial number that identifies the component. Track IDs are used for tracking
components. Track ID
Logical
The name of the file used to store dumps of the ATM CRU memory. Dump Filename
The type of transmission used by the ATM CRU. This might be either a standard, such
as SONET, or a line speed, such as 155 Mbps. Physical Transmission Type
The media access control (MAC) address of the ATM CRU. MAC Address
88 System Resources