HP Integrity NonStop J-Series - Manual (Page 155)

The hardware revision of the switch logic board. Hardware Revision
The type of CRU this SAC is connected to.
Values: SSAC, FSAC, SCSI CRU Type
Logical
The type of storage device supported by this Fiber SAC.
Values: Disk, Tape, SCSI Controller, Not Configured, Unknown Configured Type
Actions
Responsive Test
Verifies that the component is connected and responding.
G4SA
The M8800 Gigabit Ethernet 4-port ServerNet adapter (G4SA) provides Gigabit connectivity
between NonStop servers and Ethernet LANs. G4SAs are installed in slots 1 through 5 of an
I/O
Adapter Module (IOAM).
Each G4SA contains one G4SA SAC , which contains up to four G4SA PIF s, resulting in four
Ethernet ports on each G4SA. For more information about the G4SA, including diagrams to identify
specific ports, see the Gigabit Ethernet 4-Port Adapter Installation and Support Guide.
NOTE: If a ServerNet switch board is not present, G4SAs will not appear in OSM.
Location in OSM Tree: System > Group > IOAM Enclosure > IOAM > G4SA
Example: G4SA $ZZLAN.G4SA1 (13.3.2)
Attributes
G4SA
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Values
Service State
Physical
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components. Hardware Revision
The part number of the component that was assigned in manufacturing. Use
part numbers for identifying and ordering parts. Part Number
A unique serial number that identifies the component. Track IDs are used for
tracking components. Track ID
Logical
The configuration type of this resource.
Values: CCSA, E4SA, FESA, G4SA, GESA, TRSA, Unknown Configured Type
The state of the component as known to the operating system on the server.
Values
Device State
G4SA 155