Primary host connection, Alternate host connection, Actions – HP Integrity NonStop J-Series User Manual
Page 225: Start, Primary host connection alternate host connection
The name of the subnet on the alternate TCP/IP process that supports the
SWAN concentrator.
Format: TCPIP process name.subnet name
Example: $ZTCP3.#SN1
Alternate Subnet Name
The primary gateway IPv4 address configured for the SWAN concentrator.
Example: 192.168.10.30
Primary Gateway IPv4 Address
The alternate gateway IPv4 address configured for the SWAN concentrator.
Example: 192.168.11.30
Alternate Gateway IPv4 Address
Primary Host Connection
If the primary path of this SWAN concentrator is connected to a CLIM, this
attribute is the name of the primary CLIM. If the primary path of this SWAN
concentrator is connected to a PIF, this attribute is the location of the SLSA
adapter containing the primary PIF.
Format:$ZZCIP.CLIM_Name, (Group, Module, Slot)
Example:$ZZCIP.C1002581, (110, 2, 4)
Host Connection Point
If the primary path of this SWAN concentrator is connected to a CLIM, this
attribute is the name of the Ethernet interface in the primary CLIM to which
the SWAN concentrator is connected. If the primary path of this SWAN
concentrator is connected to a PIF, this attribute is the name of the LIF
corresponding to the primary PIF to which the SWAN concentrator is
connected.
Format:CLIM_Name.Interface_Name, LIF $ZZLAN.LIF_Name
Example:C1002581.eth2, LIF $ZZLAN.LANA
Host Interface
Alternate Host Connection
If the alternate path of this SWAN concentrator is connected to a CLIM, this
attribute is the name of the alternate CLIM. If the alternate path of this SWAN
concentrator is connected to a PIF, this attribute is the location of the SLSA
adapter containing the alternate PIF.
Format:$ZZCIP.CLIM_Name, (Group, Module, Slot)
Example:$ZZCIP.C1002582, (110, 2, 4)
Host Connection Point
If the alternate path of this SWAN concentrator is connected to a CLIM, this
attribute is the name of the Ethernet interface in the alternate CLIM to which
the SWAN concentrator is connected. If the alternate path of this SWAN
concentrator is connected to a PIF, this attribute is the name of the LIF
corresponding to the alternate PIF to which the SWAN concentrator is
connected.
Format:CLIM_Name.Interface_Name, LIF $ZZLAN.LIF_Name
Example:C1002582.eth2, LIF $ZZLAN.LANB
Host Interface
Actions
Start
Starts the SWAN concentrator and its associated CLIPs. When the Start action completes, the
SWAN concentrator and its associated CLIPs are in the Started state.
In a multisystem configuration, this action also causes the current system to take control of the
associated CLIPs. If any of the CLIPs are currently controlled by another system, that system loses
control of those CLIPs.
SWAN / SWAN2 225